AM29

[bill]

ON THE WEEKEND COULD NOT GET ENOUGH FRONT BITE. WE HAD 2 FULL SPACERS INSIDE SPINDLES NEUTRAL ON FRONT END. FRONT BAR NOT IN. 47.5 IN WIDE ON THE REAR-AXLE FORWARD & DOWN SHORT HUBS 75MM- 40 MM AXLE 1040 LONG TEMP 60 DEG. CLOUDY. ANY IDEAS TO GET MORE FRONT BITE. please i need help.

[Cameron]

Looks like you were too narrow in the rear. we found when the track gets a lot of grip we need to stiffen the front of the kart. Try to raise the front of the kart add the front bar narrow the front and widen the back.

With the short wheel base, the rear ride height high, and rear narrow you had a bunch of rear grip.

[bill]

DO you also run an am 29? the previous 2 weeks this set up worked great. our best finishes with this chassis.

[bill]

P S we will test the set up you suggested. always glad of any help. thanks.

[Cameron]

We run an AM 29 and an AR 28. Cameron likes both. We use the 28 for Rotax

Try to start with rear width at 52, fr 2 .5 spacers + 1/2 caster. if it turns in good but pushes coming off add the front bar, and or raise the chassis in the front. If it will not turn in try more caster

We run the rear low and long

Where do you have the seat placement?

[bill]

We run a 4 stroke. our rear width is kimited to 59 inches.

[Cameron]

I would go max width in the rear, then mess with the front, ride height, bar, ect

[bill]

thanks.

[Cameron]

What did you try? how did it help? not sure of the 4 stroke comparison but information is knowledge

[bill]

Havent had arace yet. Going to practice on sat.