suggestions for CR32 at PBIR

[rotaxmax]

I will be running a CR32SP with a 125cc TAG Parilla Leopard engine at the kart track at PBIR. Any suggestions for set up are appreciated. Thanks.

[Marc Miller]

I would use this set-up for the most part (click on R32 thread). Front width will likely be 2-bars and dial as much front brake out as you can stand. Several corners at PBIR you can trail-brake into and too much front brake will make the kart want to push or buck.

http://www.mrpmotorsport.com/community/showthread.php?t=1831

[mhershorn]

Thanks for the info. I have a deep seat mounted and the front measurements are right on: 62cm on the left front and 63cm on the right. However, the measurement from the top of the axle to the top edge of the seat is only 19.5cm. The previous owner was running this kart on a 1.95 mile road course. Any suggestions for seat position and running this kart at PBIR?

[mhershorn]

I ran the kart only 2 or 3 laps at PBIR last weekend. The clutch was smoking because the idle was too fast. Then the track was closing. I noticed there was not enough bite to the brakes. I had bled the brakes and there is a 1.5mm gap from pad to rotor. The bias front to back is equal. Any suggestions?