R30CY with 50mm axle

[RobertsRacing45]

I have ordered a new R30CY and was wondering if I could get the baseline setup for it? I saw the baseline setup for the R30CY w/ a 40mm axle but not the 50mm axle. I will be running the Tag Sr class at 350lbs on YKC's. Thanks in advance!

Matthew

[Chris Lobaugh]

1040x50x2-F, middle bearing tight, 100mm hubs at 54 1/2" wide, one seat stay each side, front bar in, spindles in the middle, 75mm front hubs set two thick and one thin spacer wide, 2mm toe out, camber will be between 0 and 2mm positive. Freeline seat mounted at 60cm from the front rail to the front edge of the seat, top of the axle to the top of the back of the seat 22cm, bottom of the seat should be 3-5mm below the frame rails...hope this helps

[RobertsRacing45]

Thank you Chris!