Baseline AR28Z setup

[Rgarmon]

I apologize if I am repeating a topic previously discussed, however I am in need of baseline setup for the AR28Z. We recently purchased two and I am in need of baseline parameters as well as seat placement recommendations. I have seen information on the C 28, however have not been able to find the info on the AR28Z. Thanks in advance.

[Chris Lobaugh]

Spindles in the middle, central pills, 5 1/8" front wheels, no front bar, one thick and one thin spacer wide. 1040-F axle in the middle and up position, short rear hubs, 1 1/2" in from the end of the axle, 5 1/8" rear wheels, no secondary seat stays...this is for MG SLE tires on a decent track (not too slippery, not too sticky).

[Rgarmon]

Chris,
Thanks for the baseline information, it is greatly appreciated. Do you have seat placement parameters?
Thanks again,
Rob

[Chris Lobaugh]

When using a standard Small Freeline Seat; from the front rail where the drivers heel would rest to the front edge of the seat 50cm on the left side, 51.5 on the right side. Top of the axle to the top edge of the seat 22cm with the axle in the middle and down position. Bottom of the seat should be flush with the bottom of the frame rails.

[Rgarmon]

Chris,
I received your emails on the setups, the info is greatly appreciated.